Network Port Figure 4. Configuring the PC for Maximum Performance Remove the PCC installation diskette and restart the computer. Enter text from picture: Install the PCC driver software as described below. Table Of Contents Windows 3.
|Date Added:||10 November 2011|
|File Size:||66.34 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Table of Contents Add to my manuals Add. This action will cause the New Hardware Found window to be displayed again. If there is no PCC currently inserted in a PC Card slot, a message appears under Windows 95 stating that the operating system has removed, or has not loaded, the PCC device driver.
As a result, both types of cards cannot run on a PC at the same time. Page 46 Table 4.
Page 2 Parts manufactured by vendors other than Echelon and referenced in this document have been described for illustrative purposes only and may not have been tested by Echelon. Table Of Contents Windows 3. This circuit in figure A. Whenever a reference document is addressed, a superscript number corresponding to the reference has been placed in the text, i.
Network Port Figure 4. Page 22 UL Listed equipment. Cogp print the manual completely, please, xorp it.
Electrical specifications for the network port of the card and related pcc-0 assemblies also are included. The default drive is C. It is the responsibility of the customer to determine the suitability of these parts for each application.
Pcc Initialization An error will be reported if an attempt is made to modify the transceiver type before the PCC card is initialized. If the computer does not display blinking options, the highlighted option will be shown as black writing on a white background.
Page 13 Page 14 – Windows 3.
Page 17 A list of available hard disk drives will be displayed. The two 2 zener diodes allow a cop offset between the cable shield and pod logic ground.
DriverMax – ECHELONPCLTA – Echelon Corporation – LonWorks PCC Network Interface Drivers Download
Unlike Windows driver conflicts, this problem is difficult to diagnose. Microsoft DOS where no Windows operating system is being used. By pressing ‘print’ button you will cor only current page. Testing the card with the Diagnostics cotp, as suggested by the error message, produces the diagnosis: It will not change until a transceiver is selected, and then configured by using the OK or Apply buttons.
Don’t show me this message again. The service pin message will not be sent if the PCC card is in the post-reset flush state see Automatic Flush Cancel.
Parts manufactured by vendors other than Echelon and referenced in this document have been described for illustrative purposes only and may not have been tested by Echelon.
Echelon Corporation LonWorks PCC-10 Network Interface how to download and install the driver
When configuring a custom transceiver or adding custom parameters for a standard transceiver, the values used in the Custom Properties Raw data edit boxes must be entered as hexadecimal byte values separated by dashes. Use the arrow keys to select the drive where the PCC Card software should be installed. PCC was installed, i. Hirose CL Figure 4.
Don’t have an account? This re-initializes the PCC card and allows use of the commands. Page of 55 Go.